Pictured is a 16" injection compression mold. Molds are designed with vacuum seals for degassing
during filling. Molds of this design can be offered in 12", 16" and 22" sizes. (305mm, 405mm and 560mm).
This mold is a rubber foot with 456 cavities. Cavities can be Stainless Steel or Tool Steel, fully hardened.
Some molds can be cut in the solid plate to help keep costs down.



Pictured is a cell concept with press and index trimmer in the same cell. This particular mold, and trimmer
set-up, is capable of 240 runs per 8 hour shift. That is a molding capacity of 109,440 pieces per shift. The
operator is responsible for molding and trimming in the cell. The pieces are completely finished when
they leave the cell, except for any postcure if necessary.


 
Pictured is a patented JL Index Trimmer, 16" size. It is designed to trim round layouts of injection
compression molded products automatically. The trimmer seats the pads before trimming to insure
high quality trims. Single station machines cycle in 30-40 seconds. Dual station machines cycle in
50-60 seconds. Trimmers are available in single or dual station models. Sizes available are 12",
16" and 22" diameters (305mm, 405mm and 560mm diameters).
© 2001 JL Machine & Tool, Inc.