Pictured is a 12" injection transfer mold. Molds are designed with integral injection cylinders.
Transfer pistons have seals which prevent rubber leakage. All molds are designed with vacuum
seal arrangements. Mold plates can be PX-5 or NAK-55 with or without ion nitriding. Cavities can
be Stainless Steel or a variety of Tool Steels, fully hardened, depending on the application. These
molds are particularly good for small product with through holes, which can be created during molding.

Pictured is a cell concept with press and index trimmer. This mold is a 300 cavity seal washer with a
through hole. This cell is capable of 48,000 pieces per 8 hour shift. The operator is responsible for
molding and trimming in the cell. The pieces are completely finished when they leave the cell, except
for any postcure if necessary.

Pictured is a patented JL Index Trimmer, 12" size. It is designed to trim round layouts of injection
compression molded products automatically. The trimmer seats the pads before trimming to insure
high quality trims. Single station machines cycle in 30-40 seconds. Dual station machines cycle in
50-60 seconds. Trimmers are available in single or dual station models. Sizes available are 12",
16" and 22" diameters (305mm, 405mm and 560mm diameters).

© 2001 JL Machine & Tool, Inc.